2001 - 2002 YZF R6

Here are the instructions for removing the 2001 R6 taillight assembly.

NOTE: Before removing tail / brake light assembly, ensure that it works properly.

1.    Take both seats off.
2.    Remove 'push-pins' from underside of fairing.  The best way to remove these is to PUSH the center pin IN with the tip of a pen or phillips head screwdriver. It will "pop" and the whole rivet is easily removed.
To re-install the rivet, pull the pin out to "reset" the rivet, insert it into the bodywork and then PUSH the center pin IN until it clicks and locks into place (Thanks lunadivolo) or use pointed scribe or similar and jam between inside pin and outside ring, then pry pin out.  The pin will come out about 1/4", and you can keep it in its holder.
3.    Remove 2 large phillips screw on front point of fairing, close to fuel tank.  Remove 2 small phillips screws in back of fairing on top, where the back of the passenger seat area is.
4.    Remove rear fairing, pulling back works well.
5.    Remove four allen head screws from inside storage area.  These hold the rear fender / license plate frame / turn signal mount assembly. Be careful when removing last screw to hold the under-fairing from falling.
6.    Remove brake light assembly with 2 phillips screws, one on each side.
7.    Send entire brake light assembly, with un-cut wiring harness to:

        M. D. Wright, Inc.
        4701 East 870th Road
        Casey, IL  62420
        800-980-3517

NOTE: A $10 charge will be added for a CUT OR MODIFIED wiring harness. Also, if you have already purchased the Integrator, and any wires have been cut or spliced, or if it is not complete, there will be at least a 20% restocking fee.

8.    When you receive the "Integrated" brake light assembly back, simply
install in reverse order.

Once we have the tail light, it should ship out within two business days.  The
Integrator Kit is $49.95 and the instalation is $60 which includes a stainless steel license plate bracket.  Return shipping and handling is $12.50 (Ground), $17.50 (Second Day), or $32.50 (Overnight).

We also have an Exchange Program. With it, we send you a new brake light assembly, that has been 'Integrated'. Then, you simply swap brake lights, and send us your original one. There is a $25 fee for the Exchange Program, but it saves you a lot of time. Note: Your brake must be in PERFECT condition to be eligible for the Exchange Program. When we send you the 'Integrated' brake light, we will charge your card for $275. Then when we recieve your brake light, we credit you the difference - $140.05 ($190 if you have already purchased the Integrator), minus shipping.

Please let us know if you have any other questions.

Ducati 748, 916 & 996

Note: Before removing tail / brake light assembly, ensure that it works properly.

1.    Unplug tail light assembly.
2.    Pull taillight out of grommets.
3.    Send entire brake light assembly, with un-cut wiring harness to:

      M. D. Wright, Inc.
      4701 East 870th Road
      Casey, IL  62420
      800-980-3517

4.    When you receive the "Integrated" brake light assembly back, simply install in reverse order.  Plug the white wire to the right turn signal connector, and the gray wire to the left turn signal connector.

Once we have the tail light, it should ship out within two business days.  The Integrator Kit is $49.95 and the install is $50. Return shipping and handling is $12.50 (ground), $17.50 (2nd Day Air), or $32.50 (Overnight).

Please let us know if you have any other questions.